![]() This command is supported in the Cisco IOS Release 12.2SX train. Support in a specific 12.2SX release of this train depends on your feature set, platform, and platform hardware. Route summarization reduces the amount of routing information in the routing tables. RIP Version 1 always uses automatic summarization. If you are using RIP Version 2, you can turn off automatic summarization by specifying the no auto-summar y command. Disable automatic summarization if you must perform routing between disconnected subnets. In the following example, network numbers are not summarized automatically: router rip When automatic summarization is off, subnets are advertised. ![]() To enable Bidirectional Forwarding Detection (BFD) for all interfaces participating in the routing process, use the bfd all-interfaces command in router configuration or address-family interface configuration mode. Router configuration (config-router) and address-family interface configuration (config-router-af) Command History To disable BFD for all neighbors on a single interface, use the no form of this command.īFD is disabled on the interfaces participating in the routing process. This command was integrated into Cisco IOS Release 12.0(31)S. 8.3.1.2 packet tracer commands software#.
0 Comments
Leave a Reply. |